Dear all,

we just released in the wiki an howto which tells how to use the USB port of the FLEX Full.

In ERIKA 1.4.3, in fact, we released a new API for sending data from the dsPIC to the PC through the USB.

That API is then used by the Scilab/Scicos code generator to send data through the USB to the PC, where Scilab can read the data using a DLL we wrote.

Some notes:
- PC to dsPIC is not yet implemented (only dsPIC to PC)
- You need at least a FLEX Full; then you need to connect the appropriate pins on the board, or you need to either connect them by hand (like in the USB application note on the Application notes section), or use a Demo Daughter board.

Ciao!

PJ