|
|
|
|
|
|
|
Another question on I2C... (1 viewing) (1) Guests
Favoured: 0
|
|
|
TOPIC: Another question on I2C...
|
|
|
|
Another question on I2C... 4 Months ago
|
Karma: 1
|
|
Hi, I have another question for you, guys...
How can I use the I2C pins on the doughter board? In other words: I have to use SCL1 (Pin 45) and SDA1 (Pin 46) on the flex board, ok? But I want to use the daughter board too, because I'd like to put some chars on the LCD screen... So: where can I find that pins on the latter board? I don't wont to solder anything on the board.. I think I'll burn it!!!
Tnx...
Alberto Savioli
|
|
|
|
|
|
|
The administrator has disabled public write access. |
nino (Moderator)
Moderator
Posts: 15
|
|
Re:Another question on I2C... 4 Months ago
|
Karma: 2
|
|
I'm sorry but the DemoBoard doesn't export an I2C bus. One of the channels is used but connected to the DACs.
The only way is to solder 2 wires. The place where doing this is less dangerous is on the connector to the Flex.
|
|
|
|
|
|
|
The administrator has disabled public write access. |
|
|
|
Re:Another question on I2C... 4 Months ago
|
Karma: 4
|
|
As an addition to waht Nino said...
the Demo daughter board does not have the pin exported, but the Multibus daughter board has them.
In any case, try to solder the wires on the big connector wires next to the LCD... there is no risk to burn anything there!
PJ
|
|
|
|
|
|
|
The administrator has disabled public write access. |
|
|
|
Re:Another question on I2C... 4 Months ago
|
Karma: 1
|
|
Ok, thank you for the advices!!
I'll try to do that...
Bye!
|
|
|
|
|
|
|
The administrator has disabled public write access. |
|
|
|
|
|
|
|
|
 |
Evidence S.r.l. - PIVA: 01638690501
Via Carducci 64/A - Ghezzano - Pisa - Italy
|
Privacy Policy
|
 |
|
|
