Are you able to correctly program the board with the other examples we provide under RT-Druid?

Where are those examples ?

I've used that because I think is the only one which leave me a feedback if something is working (because of the sys-led). I don't have any daughter board for now. I've used the MPLAB v8.00 and C30 v2.05 Student Version. I don't have any errors in programming the board, everything is ok. When I switch on sometimes work sometimes doesn't. Maybe I'm missing something but I've correcly followed the procedure. Maybe I'm wrong using the MPLAB, but I really don't know.

Thank you,
Pasquale.

Let's try to narrow the possibilities.

Try open RT-Druid, create a project using the template "simple periodic task", which basically _b_link__s the system led.

Does that application runs on your hardware? that one should have no problem.

bye

PJ

Hi,
I've just tried and it works. I have problem with generating code using Scicos. This morning the generation process stop in itself and freeze my laptop. I really don't know why. What can I do ?
I have one more question. I used the "simple periodic task" in a "Programmer mode"because I get an error using "Debugger mode" using MPLAB IDE. How can I solve that ?


Thank you,
Pasquale.

Dear Pasquale...

- did the compilation finished correctly or stopped in some point? in which point did it freeze?... There is nothing strange in the software we distribute that can freeze your laptop...

- About the debugger/Programming mode: This is quite strange; probably the jumper settings are not set correctly?

Btw... I know you are from Pisa... Are you coming to the OSEK training course next week? that could be a place to solve live your problems...

bye

PJ

did the compilation finished correctly or stopped in some point? in which point did it freeze?... There is nothing strange in the software we distribute that can freeze your laptop...

I've tried again it doesn't freeze but at some point it goes really slow in compilation. I'll send you where exactly it begin to be slow. For this reasons my laptop freeze because I cannot close the "cmd" window etc..

About the debugger/Programming mode: This is quite strange; probably the jumper settings are not set correctly?

I've followed the jumper setting written in Flex Reference Manual. Should I check some jumpers ?

I've opened MPLAB, I've imported the .elf and than I've pushed on debug etc.. Is this the procedure ?

Btw... I know you are from Pisa... Are you coming to the OSEK training course next week? that could be a place to solve live your problems...

I don't know. I've seen that there are just a few places. If there are still some free, maybe I can think about that.

Thank you,
Pasquale.

If not... you can try to just pass by on Tuesday... there are the lab experiments going on... and maybe someone will be able to spare some time to solve the issue...

PJ